Tetra Setup Assistant
Restore Settings
To restore settings previously saved from this script, paste them here and click "Restore":
Basic Settings
Complete all sections of this form at the same time. Any of the "Create Tetra Code" buttons will submit all sections of the form.
Scroller Name
The name must begin with a letter and may include letters, digits and underscores.
Scrolling direction
Right to Left
Bottom to Top
Left to Right
Top to Bottom
Scroller width
pixels
Scroller height
pixels
Item size
pixels
Enter the width if scrolling horizontally, or the height if scrolling vertically.
Gap
pixels
How many pixels, if any, to leave between items.
Item Delay
seconds
How long to pause on each item.
Step Size
pixels
Pixels to move on each step.
Step Delay
1000ths of a second
How long to wait between steps.
Refresh Delay
seconds
How long to wait between loads of data from the URL specified above, if any.
Pause on Mouse Over
Yes
No
URL to load data from (optional)
To specify static data below and not have it replaced later, leave this blank. The URL can be absolute or relative to the page that the scroller will appear on, but must be in the same website.
Allow URL change
Yes
No
If the URL above points to data that you don't have control over, and you don't wish it to be able to switch the URL, select "no".
CaRP Integration (optional)
If you'd like to use
CaRP
to insert data into the scroller, complete the following. You can use CaRP to generate the initial contents of the scroller and/or to generate dynamically updated contents. When using CaRP to generate the initial contents, leave the "Static Data" section below blank. When using CaRP to generate dynamically updated contents, the URL entered above must be the URL where you will upload the CaRP integration script that will be generated by this form.
RSS feed set name
The name can contain letters, digits, hyphens and underscores. If using the same CaRP formatting for sets of feeds elsewhere, they can use the same name.
Maximum items in scroller
Maximum items from each feed
If you are aggregating a number of feeds and wish to ensure that the scroller is not dominated by one feed that updates often, enter a number lower than the maximum number of items in the scroller.
RSS Feeds
Feed 1
Feed 2
Feed 3
To enter more feeds, complete these first and click "Create Tetra Code". More lines will be added to this form.
Static Data (optional)
To populate the scroller with static data before, or instead of loading data from the URL entered above, enter data below. You may enter any text or HTML you wish.
To enter more items, complete these first and click "Create Tetra Code". More lines will be added to this form.